How to Install Geotab’s GO Plug-&-Play Vehicle Tracking Device


GO device plug-and-play installation directly into the OBDII port Locate the diagnostic port usually found under the dashboard on the driver’s side Insert the zip-tie around the port to later secure the device Connect the GO Device to the port, push to ensure that the connection is tight You will hear 6 beeps and all 3 lights on the device will flash briefly Secure the device in place with a zip-tie Turn on the ignition, the device will beep as each one of the LEDs lights up The green LED light indicates cellular connection, The red LED light indicates that ignition
detection and the blue LED light indicates GPS latch Wait for all 3 LEDs to come on The installation is complete, to ensure that the device is communicating go to install.geotab.com
and enter the device serial number